MAF Fitment

19MUSTANG95 · 06-09-2007

When putting in a maf is it okay to go from 3.5 inch intercooler piping to a 3.5 inch maf into a 3 inch pipe going to the throttle body?

hotrodredneck · 06-09-2007

I would not see any problems with that. but make sure the MAF does not go in right after a bend.

19MUSTANG95 · 06-09-2007

It comes after a slight bend just because thats how the kit is set up but I am purchasing the new cyclone maf from anderson ford that samples air at 360 degrees so its perfect for that set up.

Beernut · 06-10-2007

Quote:

Originally Posted by 19MUSTANG95

It comes after a slight bend just because thats how the kit is set up but I am purchasing the new cyclone maf from anderson ford that samples air at 360 degrees so its perfect for that set up.

with THAT MAF you should be good to go, but with most other MAFs I would strongly suggest keeping it 3.5in for 12in before and after the MAF and STRIGHT as possible of course.

06-09-2007	#1 (permalink)
19MUSTANG95 Gold Member Join Date: Aug 2006 Posts: 175 iTrader: (0) Friends: (2) Last Online: 04-30-2009 07:56 AM Time Spent Online: 25 Minutes 10 Seconds My Album's: 19MUSTANG95's album Thanks: 0 Thanked 0 Times in 0 Posts	MAF Fitment When putting in a maf is it okay to go from 3.5 inch intercooler piping to a 3.5 inch maf into a 3 inch pipe going to the throttle body?

06-09-2007	#2 (permalink)
hotrodredneck NJ REDNECK!!!...WTF? Real Name: Jim Join Date: May 2007 Location: From NJ, Stationed in VA Posts: 131 Facebook ID: jim beebe iTrader: (0) Friends: (2) Last Online: 10-09-2010 11:03 AM Time Spent Online: 18 Hours 34 Minutes 57 Seconds My Album's: hotrodredneck's album Thanks: 1 Thanked 0 Times in 0 Posts	I would not see any problems with that. but make sure the MAF does not go in right after a bend. __________________

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Tire fitment question!	blackbetty88GT	5.0 Mustang	11	09-12-2009 03:03 AM
MAC exhaust fitment.	rockytoohot	6 Cyl (V6) Applications	2	10-21-2008 01:33 PM
more gt-40p header fitment questions	hoss	5.0 Mustang	1	03-29-2008 03:05 PM
Wheel fitment!	already7	5.0 Mustang	3	03-03-2008 09:49 PM

06-09-2007	#3 (permalink)
19MUSTANG95 Gold Member Join Date: Aug 2006 Posts: 175 iTrader: (0) Friends: (2) Last Online: 04-30-2009 07:56 AM Time Spent Online: 25 Minutes 10 Seconds My Album's: 19MUSTANG95's album Thanks: 0 Thanked 0 Times in 0 Posts	It comes after a slight bend just because thats how the kit is set up but I am purchasing the new cyclone maf from anderson ford that samples air at 360 degrees so its perfect for that set up.

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)